CASES & TROLLEYS
RESOURCES

GETTING TO GRIPS WITH MANUAL HANDLING:

Good Handling Technique For Pushing And Pulling

 

Here are some practical points to remember when loads are pushed or pulled.

 

● Handling devices.

Aids such as barrows and trolleys should have handle heights that are between the shoulder and waist. Devices should be well-maintained with wheels that run smoothly (the law requires that equipment is maintained). When purchasing new trolleys etc, ensure they are of good quality with large diameter wheels made of suitable material and with castors, bearings etc which will last with minimum maintenance. Consultation with your employees and safety representatives will help, as they know what works and what doesn’t.

 

● Force.

As a rough guide the amount of force that needs to be applied to move a load over a flat, level surface using a well maintained handling aid is at least 2% of the load weight. For example, if the load weight is 400 kg, then the force needed to move the load is 8 kg. The force needed will be larger, perhaps a lot larger, if conditions are not perfect (eg wheels not in the right position or a device that is poorly maintained). The operator should try to push rather than pull when moving a load, provided they can see over it and control steering and stopping.

 

● Slopes.

Employees should enlist help from another worker whenever necessary if they have to negotiate a slope or ramp, as pushing and pulling forces can be very high. For example, if a load of 400 kg is moved up a slope of 1 in 12 (about 5 o ), the required force is over 30 kg even in ideal conditions – good wheels and a smooth slope. This is above the guideline weight for men and well above the guideline weight for women.

 

● Uneven surfaces.

Moving an object over soft or uneven surfaces requires higher forces. On an uneven surface, the force needed to start the load moving could increase to 10% of the load weight, although this might be offset to some extent by using larger wheels. Soft ground may be even worse.

 

● Stance and pace.

To make it easier to push or pull, employees should keep their feet well away from the load and go no faster than walking speed. This will stop them becoming too tired too quickly.